Clip tie wrap from brake line tubes. Turn sheave counterclockwise on puller rod until it comes free. Slide the Low gear in and out until needle bearing slides out of gear and can be removed. The tab must be positioned in the notch on the side of the piston as shown A. If the joint is stiff or binding, tap the yoke lightly to center the joint until it pivots freely in all directions. S Turn housing over and support inner race of bearing installed in previous step. Continuity should exist between color coded wires as shown in the chart below.
You will be able to use the search function to browse the manual and print out your needed pages. Using a small flexible tube such as an oil delivery hose grasp the burned out lamp and remove it. Std ±15% Polaris Sales Inc. Reinstall battery, attaching positive + red cable first and then the negative - black cable. I don't know anything about it.
I'm lost, any help would be greatly appreciated. Using a strap wrench on splines to hold shaft, remove front output ring gear retaining bolt, lock tab washer, and flat washer. Fuel and Oil Tank Asm. A friend of ours dropped off a 90cc Polaris Scrambler at the house this afternoon. With hundreds of pages, it will show you how to distinguish any problem from an oil change to a transmission swap and how to fix it on your own. Turning right screw clockwise adjustment moves the intense spot of light up to the left.
Install new O-rings between caliper halves. Remove cover and diaphragm from master cylinder and dispose of the fluid properly. Reinstall recoil housing using a new gasket. Remove brake caliper pivot bushing from stud. Remove bushing and removal tool from adapters.
Big End Radial Clearance: Refer to page 3. Remove the two 6mm flange bolts A from cylinder head. Check brakes to be sure they are not dragging. To install housing, reverse removal procedure. Please watch the following video for a quick overview of our business. .
Coat valve stem with molybdenum disulfide grease. Thanks in advance for your help. If the bulb is good, check the wiring, transmission switch, and lamp socket ground path. If light flashes, sensor is O. Be Lock Sprocket sure to tighten properly following procedure above.
Slotted Nut Torque: 35-51 ft. Disconnect the sway bar from both sides. Specified pole gap is 0-. Compare to specifications on page 3. Refer to specific fastener torques listed in each chapter. Replace diaphragms and gaskets as a set. Always check throttle cable freeplay after adjusting idle speed and adjust if necessary.
Observe coolant levels often during the break-in period. In this position there should be clearance on all valves. Refer to O-ring the appropriate parts manual for placement and part numbers. Repeat procedure for other side. Remove chain tensioner along with mounting pins and spacers. I have a 2001 Polaris Scrambler 400 2X4. Remove six cylinder head bolts using a 12 mm socket.